What causes pipes to freeze? During the cold months, the water that comes into your house from outside much is colder than it was during the summer months. Pipes contract because of the cold water and this usually results in small cracks or leaks in the weakened parts of the pipes. Water in a crack will expand if it freezes, causing the pipe to burst. This could cause hundreds or thousands of dollars in damage to your home.
There are no practical methods to heat up the ground temperature surrounding your home. Moreover, you have no way of controlling the contraction caused by the cold water to your pipes and stopping the leaks when the temperature drops. The best thing you can do is to check your pipes for any leaks as soon as the temperatures change.
Prevent Frozen Pipes
To prevent your pipes from freezing and bursting, follow these tips.
- Lines located near a window or an outside wall are prone to freezing. Check your basement and look for any lines near the exterior of your home. Direct warm air to the colder areas of the home, where the pipes are located.
- Always run one or two faucets slowly if the outside temperature is extremely cold. Especially if the heat were to go out in your home. The pipes will not freeze when water moves through it.
- Kitchen sinks are usually on an outside wall. Leave your cabinet doors open to let warm air into the cabinet. Leave your kitchen faucet on during extremely cold weather.
- Detach your hose from the outside faucet. Water will not drain out of the hose hydrant or silcock if the hose is left attached to it. This results in frozen pipes and rupture.
- Keep your pipes warm during extremely cold weather by installing heat tapes around the pipes.
- Always check the temperature in any areas of your home where the pipes are located during cold weather. The temperature should not drop below 32 degrees.
- Check your home for any leaks that permit cold air to enter. Inspect the areas around dryer vents, electrical wiring, and pipes. Use insulation or caulk to seal the leaks and to keep the cold from getting into your home. Cold air can go into your home even through a tiny opening when the weather is severely cold, leading to frozen pipes.
- Call a licensed plumber to examine your pipes. Ask advice on how to prevent frozen pipes.
If you have any questions about preventing your pipes from freezing and bursting, call American Air for a consult.
Water is a necessity, but we should know how to conserve it. Almost 50% of our daily water usage goes down the bathroom drain. Flushing the toilet is one of the biggest ways that water is wasted in your home, followed by shower heads and faucets. Water conservation is encouraged and practiced in all areas, including those regions where it seems abundant. Hiring a Columbus Ohio Plumber to fix leaky faucets, a malfunctioning flusher, or to install an efficient toilet can help reduce your water bills without sacrificing flow.
Ways to Conserve Water
- Always check leaks from faucets and pipes. Leaky faucets, even a small drip, can waste 20 g/day. So imagine how much water is wasted with larger leaks!
- Check your toilet for any leaks. To check any leaks, add a little food coloring in the toilet tank. If there is a leak, the color will appear in the bowl within 30 minutes. It is easier and cheaper to replace the parts than it is to deal with a long term leak.
- Do not use the toilet as waste bin or ashtray. Avoid throwing toilet paper, napkins, tissues, cigarette butts, or any other small pieces of trash in the toilet. All of these extra flushes waste lots of water.
- Install low-flow shower heads and faucet aerators. Low-flow shower heads and faucet aerators are cost effective and easy to install. They are water-efficient, allowing you to save as much as 50% on water consumption and reduce 50% on the energy cost of heating the water. Low-flow shower heads and faucets consume less than 2.5 gallons of water per minute. Additional water can be saved by limiting shower time or turning off the shower or faucet when soaping up or wetting your toothbrush. Turn the shower off to rinse off and use a glass to rinse your mouth.
- Check the water meter. Monitor your water meter every two hours before and after when water is not used. Any change indicates a leak.
Water system upkeep reduces soil saturation that would prolong the life of a septic tank and minimizes any pollution caused by leaks. It also helps you save on utility bill, as well as helps prevent water pollution in nearby rivers, lakes, and local watersheds. Overworked municipal sewer systems can also lead to untreated sewage flowing into rivers and lakes. Even a small amount of water flowing from these systems reduces pollution.
At American Air plumber will not only help in reducing your water bills, we will also help in reducing pollution for a healthier environment today and for the future.